LT3500
22
3500fc
APPLICATIONS INFORMATION
To compensate the linear regulator, simply add a ceramic
capacitor from the LDRV pin to ground. Typical values
range from 0.01糉 to 1糉. Figure 9 illustrates the transient
response with a 0.47糉 output capacitor.
Linear Controller
By adding an external follower (NPN or NMOS), the LFB
and LDRV pins can be con gured as a controller (Fig-
ure 10) for a low dropout regulator with increased output
capability.
The output current capability of Figure 10s circuit is a
product of the LDRV current limit and beta of the external
NPN which is normally less than the current capability of
the LT3500. The dropout voltage for the circuit is set by the
saturation voltage of the external NPN, which is typically
300mV. The minimum V
IN
for the circuit to function prop-
erly is 2V plus the base emitter drop of the external NPN.
Replacing the NPN in Figure 10 with a NMOS transistor
can reduce the dropout voltage down to the R
DS(ON)
of the
Figure 9. Linear Regulator Transient Response
20約/DIV
3500 F09
V
OUT2
AC COUPLED
20mV/DIV
LOAD STEP
2.5mA TO 7.5mA
5mA/DIV
NMOS times the output current of the regulator. This also
increases the overall ef ciency of the system. However,
the minimum V
IN
increases to 2V plus the V
GS
at full load
of the transistor. Additionally, due to a lack of beta current
limiting, a shorted output can cause the switcher output
of the LT3500 to collapse.
Since the collector of the LDRV npn is connected internally
to V
IN
, you must consider the impact of LDRV current on
ef ciency and die temperature when con guring the linear
regulator/controller. For example, with V
IN
= 25V, LDRV =
3.3V and I
LDRV
= 10mA, power dissipation on the die will
be 217mW. For a typical 3.3V/1A switcher application,
this represents an additional 7% ef ciency loss and ap-
proximately 10 degrees rise in die temperature.
If the linear output of the LT3500 is not used, the LDRV
pin should be shorted to the LFB Pin.
PCB Layout
For proper operation and minimum EMI, care must be
taken during printed circuit board (PCB) layout. Figure 11
shows the high di/dt paths in the buck regulator circuit.
Note that large switched currents ow in the power switch,
the catch diode and the input capacitor. The loop formed
by these components should be as small as possible.
These components, along with the inductor and output
capacitor, should be placed on the same side of the circuit
board and their connections should be made on that layer.
Place a local, unbroken ground plane below these com-
ponents, and tie this ground plane to system ground at
one location, ideally at the ground terminal of the output
Figure 10. Linear Controller
L1
3.3糎
C5
0.47糉
C7
22糉
C6
22糉
R1
27.4k
R2
8.06k
C1
2.2糉
C2
0.47糉
4.5V TO 36V
R6
40.2k
R5
49.9k
C3
220pF
3500 F10
V
OUT1
3.5V
V
OUT2
3.3V
1A
D2
BAT54
D1
B240A
BST
V
IN
SW
FB
SHDN
SS
LT3500
R
T/
SYNC
V
C
LDRV
PG
LFB
PG
R4
8.06k
R3
24.9k
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LT3507HUHF#TRPBF
IC REG QD BUCK/LINEAR 38-QFN
LT3570IFE#TRPBF
IC REG BUCK/BST/LINEAR 20TSSOP
LT3645HMSE#TRPBF
IC REG DL BUCK/LINEAR 12-MSOP
LT3694IFE-1#TRPBF
IC REG TRPL BUCK/LINEAR 20TSSOP
LT4220IGN#TR
IC CTLR HOTSWAP DUAL 16-SSOP
LT4250LCN8
IC CONTRLR HOT SWAP NEG 48V 8DIP
LT4254CGN
IC CTRLR HOTSWAP POSVOLT 16SSOP
LT4256-1IS8#TRPBF
IC CTRLR HOTSWAP HV LATCH 8SOIC
相关代理商/技术参数
LT3500HMSE-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500HMSE-TRPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IDD#PBF
功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IDD#TRPBF
功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IDD-PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IDD-TRPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500IMSE#PBF
功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500IMSE#TRPBF
功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*